TAS 733-200 Crush Fixture

The TAS 733 Fixture is designed for use on a tensile tester, like the VantageNX.  This crush fixture is used as the foundation to perform ring crush, pin adhesion, edge crush, Concora crush and flat crush. The fixture incorporates a guided platen design to ensure compliance with published specifications for parallelism and lateral movement. 

All crush fixtures must be ordered separately.  

Description

The TAS 733 Fixture is designed for use on a tensile tester, like the VantageNX.  This crush fixture is used as the foundation to perform ring crush, pin adhesion, edge crush, Concora crush and flat crush. The fixture incorporates a guided platen design to ensure compliance with published specifications for parallelism and lateral movement.  

Special Compression Fixture
Bearing guided platen assembly

  • Material: Steel, nickel coated
  • Maximum Capacity: 5 kN
  • Working Area: 141 cm2
  • Maximum Opening: 60 mm
  • Lateral Movement: < 0.050 mm (0.002”)
  • Parallelism: 1 part in 2000 throughout the test
  • Conforms To:
    ISO 3037-2013, ISO 12192-Fig1, TAPPI T822, TAPPI T811
  • Examples of Common Crush Tests:
    Edge Crush Test (ECT)
    Concora Crush Test (CCT)
    Ring Crush Test (RCT)
    Pin Adhesion Test (PAT)

*Specific fixtures to meet crush test standards must be ordered separately including but not limited to ring crush, pin adhesion, edge crush, Concora crush and flat crush.

Additional information

Capacity

5 kN

Standards

ISO 3037-2013, ISO 12192-Fig1, TAPPI T822, TAPPI T811

Maximum Opening

60 mm

Downloads

Crush Fixture TAS733