They Rycolab RL-RUB-A determines the ink abrasion resistance and dirtiness characteristics on different supports (paper, cardboard, ceramic, etc.).
The test consists of rubbing a sample against a defined weight (2 lb or 4 lb) at different speeds. After ending the test, the results will be visually observed.
The equipment presents four different speeds :
- 21 cycles/minute. Half the speed of the old Ink Rub Testers. This speed facilitates the wet tests and tests under 5 cycles.
- 42 cycles/minute and 85 cycles/minute. Same speeds as in the old Ink Rub Testers.
- 106 cycles/minute. Fast speed.
These speed characteristics allow users to adequate the test process to their own products.
The highest speed will reduce test times, necessary for some substrate types (plastics, UV varnishes, printed films, etc.).
The equipment incorporates a touch panel, from which the test speed and cycles are controlled. Optionally, the equipment can be supplied with heating weights (2 lb and 4 lb) with a working temperature up to 200 ºC. This option is useful when needed a faster test process (for high resistance inks and varnishes).
The test process is simple. Just introduce the desired number of cycles for the test and the equipment will end the test automatically after reaching the programmed cycles. The touch panel will display the speed and cycles values, the weight used in the test and the temperature conditions (when using heating weights).
ASTM D5264, ASTM F1571, ASTM F 2497, TAPPI T830, FINAT FTM 27, Sutherland-Method